Subsystem: Intel Corporation 4 Series Chipset DRAM Controllerįlags: bus master, fast devsel, latency 0Ġ0:01.0 PCI bridge: Intel Corporation 4 Series Chipset PCI Express Root Port (rev 03) (prog-if 00 )įlags: bus master, fast devsel, latency 0, IRQ 24īus: primary=00, secondary=01, subordinate=01, sec-latency=0 Retry short limit:7 RTS thr:off Fragment thr:offĠ0:00.0 Host bridge: Intel Corporation 4 Series Chipset DRAM Controller (rev 03) Mode:Managed Access Point: Not-Associated Tx-Power=20 dBm Wlx9cefd5ff4ac0 IEEE 802.11 ESSID:off/any I wonder if I have to blacklist or install the Fedora driver. This box was running CrunchBang Waldorf since it came out, it's a playground.Įdit: For grins and giggles, I found an old installation of XP and loaded up the XP drivers. If I have to, I'll lug the thing back into the other room and hook it up.īTW, I've tried Gentoo from the tarball. That's why I didn't copy all the actual output. The PAU06 was NOT hooked up to this computer until I did that move to buster. I screwed around and moved the system to buster from a clean install through a wired connection in another room. The cable modem is Arris TG862 (Spectrum/TW/BrightHouse). When I lsmod, the following modules are listed and in order: When I lsusb, the adapter shows up on the usb bus.
Only the Realtek RTL8111/8168/8411 controller is listed.
When I plug a different adapter in at the same time, the system recognizes and states exactly what it is. It does see all the networks in the neighborhood. I need a little help with my new Panda Wireless USB Adapter.
0 kommentar(er)
